您好,欢迎来到土木商易宝请登录注册
  • 955硅酮结构密封胶价格
  • 955硅酮结构密封胶价格
  • 955硅酮结构密封胶价格
  • 955硅酮结构密封胶价格
  • 955硅酮结构密封胶价格
  • 955硅酮结构密封胶价格
  • 955硅酮结构密封胶价格
  • 955硅酮结构密封胶价格
  • 955硅酮结构密封胶价格
  • 955硅酮结构密封胶价格

详情介绍

955硅酮结构密封胶价格

丁基橡胶密封腻子具有很好的气密性,较好的粘接强度,极强的自粘性和变形性,可以不用粘接剂,在一定条件下与新浇混凝土直接粘接,克服过去止水材料因与混凝土界面粘接不牢引起的环浇渗漏问题,可广泛用于水利水电工程及各类工业民用建筑工程。

With very good air tightness Ding Ji rubber sealing putty, better adhesion strength, self adhesive and strong deformation, without adhesive, direct bonding with concrete under certain conditions, to overcome the past problems due to leakage of sealing material for casting ring bonding with concrete interface caused by unstable, can be widely used in water conservancy and Hydropower Engineering all kinds of industrial and civil building engineering.

丁基橡胶密封腻子使用方法:

Application method of Ding Ji rubber sealing putty:

1、采用本品时应按设计要求及施工需要采用相应规格的产品。·

1, the use of the product should be in accordance with the design requirements and construction needs to adopt the corresponding specifications of the product. A.

2、待上一段砼浇注工序完成,硬化干燥后,将其清除干净,将本品直接粘巾在施工缝界面上,开始进行下一段的施工。

955硅酮结构密封胶价格

2, to be a section of concrete pouring process completed, hardened and dried, clean it, the product will be directly stuck in the construction joint interface, began the next section of the construction.

3、因施工需要也可预先留下定位浅槽,待与本产品直接接触的施工面硬化干燥后清除干净,将其镶嵌在预留槽中,按压密实即可。

3, due to the construction needs can also be left in advance positioning shallow groove, to be directly contacted with the construction surface hardening drying after cleaning, inlay it in the reserved groove, press dense.

4、需要接头时,可将其侧向压扁搭接5cm以上压水即可。

4. When the joint is needed, it can be pressed laterally and lapped over 5cm to press water.

5、施工表面应坚实,干燥,无油迹,无浮土,无积水。在使用时或运输中应注意防火及雨水,如不慎雨淋,待凉干后可继续使用,效果不减。

5, the surface should be solid, dry, no oil, no dust, no water. In use or transportation, attention should be paid to fire prevention and rainwater, such as careless rain, can continue to use after cooling, the effect is not reduced.

6、雨天不宜施工,因天气寒冷可采取人工增温方法使用。施工温度应在20℃以上,如有条件可铺助增温效果更佳。如有特殊情况可同设计部门,施工单位协商解决。

6, rainy days are not suitable for construction, because of the cold weather can take artificial warming method use. Construction temperature should be more than 20 degrees, if the conditions can be paved to help increase the temperature effect is better. In case of special circumstances, the design department and construction unit can solve the problem through consultation.

桥梁伸缩缝:指的是为满足桥面变形的要求,通常在两梁端之间、梁端与桥台之间或桥梁的铰接位置上设置伸缩缝。要求伸缩缝在平行、垂直于桥梁轴线的两个方向,均能自由伸缩,牢固可靠,车辆行驶过时应平顺、无突跳与噪声;要能防止雨水和垃圾泥土渗入阻塞;安装、检查、养护、消除污物都要简易方便。 在设置伸缩缝处,栏杆与桥面铺装都要断开。

955硅酮结构密封胶价格

Bridge expansion joints: to meet the requirements of bridge deck deformation, the expansion joint is usually installed between the two beam ends, between the Liang Duan and abutment or the hinge position of the bridge. Requirements of expansion joints in two directions parallel and perpendicular to the axis of the bridge, can free expansion, firm and reliable, the vehicle had to be smooth, no sudden jump and noise; to prevent rainwater and waste soil infiltration obstruction; installation, inspection, maintenance, eliminate dirt to be simple. At the expansion joint, the railing and the bridge deck should be disconnected.

桥梁伸缩缝的作用:在于调节由车辆荷载和桥梁建筑材料所引起的上部结构之间的位移和联结。斜交桥的伸缩装置一旦被破坏,将严重影响行车的速度、舒适性与安全,甚至造成行车安全事故。

The role of bridge expansion joints is to adjust the displacement and connection between the superstructure caused by the vehicle load and the bridge building materials. Once the telescopic device of the skew bridge is damaged, it will seriously affect the speed, comfort and safety of the train, and even cause traffic accidents.

伸缩缝按照性能及安装方法可以分为:GQF-C型、GQF-Z型、GQF-L型、GQF-F型。

According to the performance and installation method, the expansion joint can be divided into GQF-C, GQF-Z, GQF-L and GQF-F types.

其中GQF-MZL型数模式桥梁伸缩缝装置,是采用热轧整体成型的异型钢材设计的桥梁伸缩缝装置。GQF-C型、GQF-Z型、GQF-L型、GQF-F型伸缩缝装置适用于伸缩量80mm以下的的桥梁接缝,GQF-MZL型伸缩缝装置是由边梁、中梁、横梁和连动机构组成的模数式桥梁伸缩缝装置,适用于伸缩量80mm-1200mm的大中跨度桥梁。



企业名片

衡水宏业工程橡胶制品有限公司

 

 

 

衡水宏业工程橡胶制品有限公司

[未认证会员]

主营业务:我公司专业生产橡胶止水带、外贴式橡胶止水... [详细]

联系人:段佳瑞

经营性质: 材料供应商

所在地:河北 衡水市 

公司介绍

进入商铺
企业样本 更多>>

你可以通过以下类目找到类似信息:

建筑材料 > 防水 > 密封材料 > 密封胶 > 单组份聚氨酯密封胶

联系电话

  • 0519-68887188-0(查号)
  • 0519-68887188-3(在线教育)
  • 0519-68887188-4(商易宝会员)
  • 0519-68887188-5(广告合作)
  • 0519-68887188-0(内容侵权举报)

客户服务

  • 0519-68887188-5(商易宝客服)
  • info@co188.com
  • 关注土木在线:
    土木在线官方新浪微博
    土木在线官方腾讯微博
    土木在线官方微信
网上110报警 不良信息举报中心 电子营业执照